#china #PCB


For pcb manufacturers, a China pcb milling machine is essential as it has roots in CNC milling technology as well as it is fairly straightforward. It has a highly accurate NC milling table as well. Machine control commands and positioning information are sent to the controlling software through parallel or serial port. The controller takes all the responsibilities of all the positioning components whether they are working according to the requirements or not.
Creating a pcb prototype is beneficial in all aspects. A quick takeaway on the spindle of the China pcb milling; the speed should range from 30,000 RPM to 100,000 RPM. It often depends on the milling system itself. The higher the speed of spindle is, the better the accuracy will be seen. On the other hand, the smaller the tool diameter of the machine, the higher the RMP would be needed. Non-monitored stepper motors are comprised by this drive system for the X/Y axis. Already monitored stepper motor is provided by the more advanced systems.

While developing a pcb prototype of China pcb, stepper motors are used to drive a lead screw for the X and Y axis drive system. The lead screw is linked in turn to the gantry through a special machine connection assembly. The gantry is guided using dovetailed or linear bearing just to maintain the correct alignment during the process of milling. A software for user control is provided by most of the X/Y drive systems. It determines the speed of stepper motors and make it easy to determine it in all the axes respectively.

The drive and control for Z axis are handled in different ways. A way in which a simple solenoid is pushed against a spring and after the solenoid is energized, the spring is pushed down due to the push applied by the solenoid. The amount of force that is exerted on the spring as well as the rate of descent on the spring stop should be adjusted manually. Also, set it by mechanically adjusting the position of the plunger of solenoid.
Major challenges that come while developing a pcb prototype of China pcb is handling the variations in flatness that come during the milling. Conventional etching techniques are relied on optical masks so that it can sit right on the copper later. They can cause slight bends in the materials of the pcb prototype.

Any kind of minute height variations can encounter, especially, when the milling causes conical bits that either rises of the surface or it sink deeper while leaving an uncut section. Perform height mapping probes all across the board to measure all the height variations. Adjusting the Z values in the G-code is also important.

Pcb prototype can be machined with conventional conical d-bit cutters, spade mills, and endmills. D-bits cutters and spade mills are cheap because they allow traces to get closer to each other as it has a small point that helps in doing so. This is the whole brief mechanism that completes the China pcb
milling.

ChinaPCBOne Technology LTD. is the author of this article on China pcb. Find more information, about Pcb prototype.

Mechanism System Behind CHINA PCB Milling